VoIPSupply Labs: Integrating Nokia "E" Series Phones with Switchvox PBX (Plus Asterisk or any SIP IP PBX)

Do you already own a Nokia “E” Series mobile phone, or are you considering purchasing one? The Nokia “E” series phones, although not inexpensive, offer the flexibility of both GSM and WiFi/SIP calling, and can be integrated with most SIP based IP PBX platforms. For the purpose of this article, we chose a Nokia E51 and configured it to leverage any open WiFi connection to register with our Switchvox IP PBX.

These instructions apply to and of the Nokia “E” series dual mode GSM/WiFi mobile phones.

NOTE: The SIP registration instructions below assume you have already setup your WLAN settings on the phone, and will use WiFI to communicate to your SIP server. It is always suggested to have the AP on the same network as the IP PBX and to place a certain level of security.

1. First, power on the Nokia “E” series phone by holding down the power button located on the top of the phone.

2. Allow the unit to boot to the main screen.

3. Press the menu option button at main screen.

4. 4. Select the Tools Option.

5. Select the Settings Option.

6. Scroll to the Connection option and select.

7. Scroll to the SIP Settings option and select.

8. Select the Options button and select “New SIP Profile”.

9. Enter the following information in the SIP Profile:

• Profile Name : Any name you desire
• Service Profile: IETF
• Default Access Point: (Choose the AP that is on your phone network)
• Public User Name: sip: @

Example 2391@192.168.7.77 where 2391 is the extension and 192.168.7.7 is my Asterisk IP PBX IP Address.

• Use Compression: NO
• Registration: Always ON
• Use Security: NO

10. Select the Proxy Server option and make the following changes:

• Proxy Server IP Address: sip:
• Realm: asterisk (must be different for each Nokia device, as you will get an error if the same realm is used for multiple Nokia devices)
• Username: <extension>
• Password :
• Allow loose routing: YES
• Transport Type: UDP
• Port: 5060

11. Select the Register Server option and make the following changes:

• Registrar Server Address: sip:
• Realm: none
• Username: none
• Password: none
• Transport Type: UDP
• Port: 5060

12. Back out of the SIP Profile after you have saved your changes. Hover over the profile you have just created and press the options button.

13. Scroll to the Default Profile option and Select.

14. Choose your profile that you just created and set as the default profile, press OK.

15. Back out of the Connections Option by pressing the back button.

16. Select the Phone option and then select the Call option.

17. Edit the following Call setting parameters:

• Send My internet call… : YES
• Internet call waiting: Activated
• Internet call alert: ON
• Default Call Type: Internet Call

18. Save changes and back out of Phone settings.

19. At this point, you should be registered to your IP PBX. To verify this, access the Connection settings and access the SIP Settings.

20. The registration state will be displayed under your SIP profile.

21. Back out of the Connection menu, Settings menu, and into the MAIN menu.

22. Select the Connectivity Setting.

23. Select the Internet Tel setting.

24. Choose the Access Point (AP) that your SIP Account is using and select. The phone will now connect your IP PBX via this access point.

25. Upon completion, the phone’s connectivity status will be “connected” (Note, if your SIP Profile is not registered, your connectivity will always fail, you must be “registered” in order to connect)

26. Finally, to test, make test calls to other extensions on your IP PBX.